Tel: +86-020-31214276

E-mail: gzqx@cnqxjd.com

Home > News > Content
Cleaning method of Air compressor
- Aug 06, 2018 -

The long run of air compressor will cause the equipment to be blocked by scale, which will reduce the efficiency, increase energy consumption and shorten the life span. If the scale can not be cleared in time, you will face equipment repair, downtime or scrap the risk of replacement. For a long time traditional cleaning methods such as mechanical method (scraping, brush), high-pressure water, chemical cleaning (pickling) in the air compressor cleaning up a lot of problems: can not completely remove scale and other sediments, and equipment corrosion, residual acid on the material produced two corrosion or corrosion, resulting in the replacement of equipment, in addition, cleaning waste liquid toxic, A large amount of money is needed for wastewater treatment. Enterprises can use high-performance environmental protection detergent to avoid the above situation, it has high efficiency, environmental protection, safety, non-corrosive characteristics, not only good cleaning effect and no corrosion of equipment, to ensure the long-term use of air compressor. Foschtek Cleaning agent (special wetting agent and penetrating agent) can effectively remove the most stubborn scale (calcium carbonate) produced in water equipment. Rust, grease, sticky mud and other sediments, at the same time will not cause harm to the human body, will not be steel, copper, nickel, titanium, rubber, plastics, fiber, glass, ceramics and other materials to produce erosion, pitting , oxidation and other harmful reactions, can greatly prolong the service life of the equipment. Case Description: Atlas Copcor Press model for ga315w-8.5, shaft power 315KW, rotate speed 1492 r/min, exhaust volume 864l/s, washing head temperature of 97 ℃, oil temperature of 86 ℃, the compressor head temperature more than 100 ℃ equipment alarm, More than 110 ℃ device jumps. Before cleaning the operating temperature is near the alarm temperature of the equipment, it is urgent to swap the heat system for cleaning. Enterprises using Foschtek cleaning agent, after four hours of cleaning, the cleaning of the equipment immediately after the operation, cleaning head temperature of 83 ℃, oil temperature of 72 ℃, temperature drop more obvious, in line with enterprise requirements。